AusHeat Series 9 consists of 1 class:

• We will be using the 06 updated 2005 V8SC mod.

The V8 Supercar races consist of two 20-30 minute races. Qualification is used to determine start positions for the first race, and the finishing positions are reversed for the grid of the second race.

For this series we are using standing starts; when the cars are released for the rolling start, just hit the brakes and then form up in a block grid, or using the track's grid markers where available. A pace lap at 75% pace is performed for the second race only to allow everyone to assume the correct position.

When the driver in last position sees that the grid is formed up, he announces "10" to indicate 10 seconds until the start. After approximately 10 seconds the pole-sitter types "Go!" and the race is on. Pitting is not usually required except to repair damage, however for some races a compulsory pit stop will be required (usually the second race).

AusHeat Series 8 results table

AusHeat Series 6 results table

AusHeat Series 5 results table

AusHeat Series 4 results table

AusHeat Series 3 results table

Points are allocated as follows:

If you fail to complete a race (disconnected, too far behind, etc.) you will be given points as though you had finished one place behind the last finisher.

If you fail to show up for a race, you will be given points as though you had finished two places behind the last finisher.

An additional point is given for the fastest lap in each race.

Home